Check the paper storage conditions. Entering the address 1. Paper feed shaft unit Figure 6. Open the bypass tray and paper conveying unit. Purpose To prevent variations in halftone due to differences in drum sensitivity. A selection item appears. Primary feed conveys paper from the upper drawer, lower drawer or bypass tray to the left and right registration rollers, at which point secondary feed takes place and the paper travels to the transfer section in sync with the printing timing.

Uploader: Arajind
Date Added: 12 February 2009
File Size: 31.43 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 51268
Price: Free* [*Free Regsitration Required]

Also to clear the counts after replacing consumable parts. Remove the mitq portion of the printer cover by firmly pressing with a tool, such as a screwdriver, and refit the printer cover to the copier. A paper jam in the clutch malfunctions. Pull the drum shaft out and remove the drum.

The storing locations of the pins are marked inside the front cover. Be respectful, keep it civil and stay on topic.

  KODAK DC290 CAMERA DRIVER DOWNLOAD

U Changing the copy count timing Mira Changes the copy count timing for the total counter and other counters. ST paper feed unit Bushing Figure This manual also for: Contact glass Procedure 1. Tapes Pins Figure 7. Input tray – sheets size: U Setting the exposure density gradient Description Changes the exposure density gradient in manual density mode, depending on respective image modes text, text and photo, photo.

Remove the printer cover, rear cover and left cover. Remove the pins holding light source units 1 and 2.

Original feed guide 2. Also See for KM Instruction handbook manual – 54 pages.

Kyocera Mita KM Toner Cartridges & Supplies

Power Power Consumption Standby. Replace the exposure lamp and refit all the ,yocera parts. Remove the DF original switchback cover see page Purpose To check duration of use of the exposure lamp. Purpose To check the automatically set toner sensor control voltage.

Generates the laser beam which forms a latent image on the drum.

  ADAPTEC 29160 WINDOWS DRIVER DOWNLOAD

Purpose To check scanner operation. Replace the drum and refit all the removed parts. Check the paper storage conditions.

Download Center

Pull out the drawer. U U U P. Remove the image formation unit see page Cleaning blade It is automatically cleared when U is executed. Remove the stop ring, and then remove the Stop ring DF feed pulley. Kyoceta Copying without paper Description Simulates the copy koycera without paper feed. Page – Adjusting magnification of the scanner i Remove the stop ring and bushing holding the bypass paper feed shaft unit and then the unit.

Secure the printer board to the copier using the two pins removed in step 3.